PALOMAR TX 200 SOLID STATE BI LINEAR AMPLIFIER HAM RADIO

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

PALOMAR TX 200 SOLID STATE BI LINEAR AMPLIFIER HAM RADIO:
$224.95

Rare Palomar TX 200 solid state bi linear amplifier with original instruction spec sheet & schematic. Rated @ 200 watts RMS. The electronics under top cover are all original, look new with no leaking capacitors or burnt resistors & zero corrosion. Schematic shows 7 transistors and 5 diodes plus 3 led\'s. Stored unused since the mid to upper 70\'s & worked perfectly before being stored away in a humidity controlled room as all my dads equipment was in his house. The warranty tamper label on side of cover is brittle and half of label fell off above seam from storage, tamper label on heatsink is fully intact on back. The face plate has a scratch as seen in photo\'s, toggle switch\'s click very nice, heatsink is shiny clean with no corrosion. The cover has a nice wrinkle finish black. The amplifier will be packed very well & insured for safe travel to your door, thanks for looking. INSTRUCTION SPEC SHEET: frequency range- 7mhz to 30 mhz, output power-200 watts rms to 50 ohms with 3 watts rf drive, input power-transmitting 13.6 vdc at 25 amps. standby 13.6 vdc at 65 milliamps with receive pre-amp on 150 milliamps, description: stable solid state circuitry provides a minimum transmitted gain of 64 times. no tuning required. will work on any signal of 1 watt or more. automatic switching, using rf power from your transceiver no internal connections are required to your existing equipment . side band delay switch. long life solid state lamps. silicon transistor preselector provides an approximate gain of 3 decibels on received signal. transistors & diodes: 1-1n3491-r or equivalent, 2-1n4001, 1-s10-12, 4-tx-100, 2-2n2905a, 2-1n914, 3-led\'s. installation: connect tx-200 to 12 volt battery using no. 10 wire or larger, if distance to battery is 6 feet or less. use no. 8 wire or larger if distance is more than 6 feet. observe polarity. install tx-200 where adequate air flow is available to cool the amplifier. *connect both positive and negative leads directly to battery. failing to do so may result in a distortion of the transmitted signal.